Flowtite® GRP Fittings | RPC Pipe Systems
page-template,page-template-full_width,page-template-full_width-php,page,page-id-256,bridge-core-3.0.1,qode-page-transition-enabled,ajax_fade,page_not_loaded,,qode_grid_1300,qode-theme-ver-28.7,qode-theme-bridge,disabled_footer_top,qode_header_in_grid,wpb-js-composer js-comp-ver-6.9.0,vc_responsive

Flowtite® GRP Fittings

GRP Fittings


RPC Pipe Systems manufacture fabricated Flowtite® GRP pipe fittings to suit any application or design requirement.

The following is a standard list of fittings, however, any specific design can be accommodated:

  • Bends (Mitred in any angle eg, 90 deg, 45 deg, etc)
  • Tees (Equal, hydrant, Scours, etc)
  • Wyes
  • Flanges; either full face or backing ring (& blind flanges)
  • Reducers
  • End Caps

RPC Pipe Systems is also able to pre-spool section of pipework in the workshop to allow easy site assembly.  This is especially helpful if the pipe section require rigid joints, as it can save time onsite performing the rigid (Butt & Strap) joining.